
FR Maenofferen Quarry Long Tank Wagon (16mm)
£99.00
Polyamide body with resin axleboxes suitable for Slaters Wheelsets.
Out of stock
This unusual and fascinating wagon was constructed from 3 wagons for the use of the Maenofferen Slate Quarry. The tank itself is welded from two smaller tanks, and is mounted on a modified FR Long Slab Wagon which has had its wheelbase altered and end stops added the couplings.
The model is in 4 main parts plust he usual plug in axleboxes: The underframe is supplied as a single piece with interlocking couplings, The tank is split in half (prototypically) and the filler is sprued to one of these halves. Assembly is a simple case of removing the remains of sprues between the holding down straps, cutting the filler out of the tank half and removing it's sprue and then joining the halves and gluing the filler in place. The assembled tank can then be fitted to the underframe and secured in place with axle pins in the ends of the holding down straps. Note that these align with the end most of the holes in the underframe, and that the tank overhangs are different at each end. (The filler end is the longest overhang). Fit the wheels and axleboxes and as a final touch a shot length of wire can be inserted in the top of the filler end holding down straps passing through the simulated nut and bolt heads modelled on the straps.
About the kits:
- Type ‘A’ Wagons are ‘Body with Buffer’. These feature a one-piece main bodyshell, designed to be used with Coast Line Axleboxes. The axleboxes are retained by crossdrilling through the pilot holes in the solebar 1mm and gluing in retaining pins with dummy nut or bolt heads. Coupling Hooks are usually attached by a wire link to the buffer/coupler or drawbar printed as part of the main body. Couplings must be purchased spearately, but axleboxes are included.
- Type ‘B’ Wagons are ‘Body Only’. These feature a one-piece main bodyshell, designed to be used with Coast Line Axleboxes and separate Cast Metal Buffer/Coupling units. They require only simple assembly, the axleboxes are retained by crossdrilling through the pilot holes in the solebar 1mm and gluing in retaining pins with dummy nut or bolt heads. The couplings are normally retained by a 16 or 14BA bolt through the tail of the coupling, locking it to the wagon ‘spine’. Some are bolted to the headstock, and others use D link shackles which may be closed by bolt or pin. Couplings must be purchased spearately, but axleboxes are included.
- Type 'C' Wagons are 'Complete with Couplings'. On Iron Wagons the couplings are normally printed integral with the wagon body, no assembly being required.
Tools required for assembly:
- A 1.05mm drill bit in pin chuck is required for crossdrilling the axlebox pin holes
| Weight | 50 g |
|---|---|
| Dimensions | 150 × 55 × 55 mm |
| Railway Company | |
| Builder | |
| Product Type | 3D Print Kit |
| Material | Acrylate Resin, Polyamide (Nylon) |
| Gauge | 32mm |
| Scale |







