FR 3 Ton Iron Unbraked Slate Waggon, BM2B, C Type (16mm)

£40.00

One-Piece Polyamide body with resin axleboxes suitable for Slaters Wheelsets.

1 in stock (can be backordered)

The 2nd iteration of 3 Ton Slate Wagon was also built by Brown Marshall. In contrast the to the underframe being fabricated from angle, the new version was fabricated from large Z section channels, arranged as a picture frame and mitred in the corners. The corners were closed on the underframe portion by forged corner plates which also extended outwards to meet the bodywork corner angles which were extended downwards below the floor. 4 variants were produced:

a) Unbraked, dumb buffers and plain axleboxes - 67 built

b) Unbraked, spiral sprung buffer and plain axleboxes - 3 built (This Model)

c) Braked, dumb buffer and split axleboxes - 28 built

d) Braked, spiral sprung buffer and split axlebox - 2 built

 

About the kits:
  • Type ‘A’  Wagons are ‘Body with Buffer’. These feature a one-piece main bodyshell, designed to be used with Coast Line Axleboxes. The axleboxes are retained by crossdrilling through the pilot holes in the solebar 1mm and gluing in retaining pins with dummy nut or bolt heads. Coupling Hooks are usually attached by a wire link to the buffer/coupler or drawbar printed as part of the main body. Couplings must be purchased spearately, but axleboxes are included.
  • Type ‘B’  Wagons are ‘Body Only’. These feature a one-piece main bodyshell, designed to be used with Coast Line  Axleboxes and separate Cast Metal Buffer/Coupling units. They require only simple assembly, the axleboxes are retained by crossdrilling through the pilot holes in the solebar 1mm and gluing in retaining pins with dummy nut or bolt heads. The couplings are normally retained by a 16 or 14BA bolt through the tail of the coupling, locking it to the wagon ‘spine’. Some are bolted to the headstock, and others use D link shackles which may be closed by bolt or pin. Couplings must be purchased spearately, but axleboxes are included.
  • Type 'C'  Wagons are 'Complete with Couplings'. On Iron Wagons the couplings are normally printed integral with the wagon body, no assembly being required.
Tools required for assembly:
  • A 1.05mm drill bit in pin chuck is required for crossdrilling the axlebox pin holes
Weight 50 g
Dimensions 150 × 55 × 55 mm
Railway Company

Builder

Product Type

3D Print Kit

Material

Acrylate Resin, Polyamide (Nylon)

Gauge

32mm

Scale

You may also like…