FR Wagon 220 now available

I am very pleased to be able to offer these FR inside bearing slate waggons from my own printer. They are a slow print which sadly makes them pricier than I would have liked, however it is still cheaper than me outsourcing them (and far better quality too!). At 11 hours each to print, I won't be over run with stock any time soon, however they are available to buy on back order, for dispatch as soon as I can get them printed. They use SLS nylon axleboxes secured with resin printed pins mimicking studs with doubles quare nuts. The axleboxes accept Slater's axles, or alternatively a slightly more refined solution is to cut some 4mm OD/3mm ID brass tube to just under the back to back of the wheelset, fit two axleboxes to the tube and space correctly. This then becomes a very large bush for 3mm steel axles which Slaters wheels will just push onto. This later option should give the best performance, however with the axleboxes being Nylon, I do not expect any trouble running without any liners.

Please excuse my workbench! These are cruel photos showing wagon bodies immediately after removal from the curing chamber, they have not been cleaned up. You can also see an experimental coupling on one end.

At the moment, these are slated to be supplied with Bronze cast couplings from Shapeways, which greatly adds to the cost. I am hoping to be able to find a tough enough resin to supply them in plastic for a much lower price, with the option for a Bronze one should you wish.

Available to buy now without couplings at £32 including axleboxes, Click here to go to the shop.

Share This Post
Alan Jones
Alan Jones
Articles: 44